AC Repair
Low charge, compressor faults, blower and fan motor replacement, contactor and capacitor service, and refrigerant leak repair on split and rooftop units.
Panel / Residential & Commercial HVAC
Air conditioning and heating diagnostics run from one panel.
Every service call starts with a measurement rather than a guess. We read static pressure, refrigerant charge, superheat, subcool, and electrical draw before recommending parts, so the repair order matches the actual fault.
(858) 387-6551CalloutSame day
CoverageCity + suburbs
EquipmentSplit & rooftop
Control panel modules
Heating Repair
Furnace ignition faults, limit and rollout switches, heat exchanger inspection, gas valve checks, and heat pump reversing valve and defrost problems.
System Maintenance
Scheduled service covering coil cleaning, filter replacement, drain line flushing, belt and bearing checks, and electrical terminal inspection.
Thermostat & Control Service
Thermostat replacement and programming, control board diagnostics, wiring faults, and integration checks for smart and multi-stage equipment.
How the loop is read
Refrigerant moves through a closed loop between the indoor and outdoor equipment. A technician can measure its behavior at the gauges, at the coil surfaces, and at the electrical panel, which is enough to separate a refrigerant problem from an airflow problem from a controls problem.
- Static pressureConfirms the blower can move the air the duct system expects.
- Superheat / subcoolShows whether the coil is loaded correctly or starved of refrigerant.
- AmperageCompared to the nameplate to catch a motor or compressor running hard.
- Drain flowClear drainage means the evaporator can finish a cooling cycle.
INDOOR
Indoor unit
Filter
Coil
Air path — supply
OUTDOOR
Condenser
Controls
Refrigerant line set
Service sequence
- 01
Inspect
Read the complaint, check the filter and airflow path, and look for physical damage on the indoor unit and outdoor unit.
- 02
Measure
Gauge the system, verify superheat and subcool, measure static pressure, and record amperage at the unit.
- 03
Adjust
Clean coils, clear the drain, replace the filter, correct the charge, and address any wiring or capacitor fault found.
- 04
Maintain
Set the service interval, note wear items to watch, and document the readings so the next visit has a baseline.
Report a fault and we will book a diagnostic visit.
Include the system type, the symptom, and where the outdoor unit is located. That gets the right technician and the right parts on the first trip.